Creator's Studio
  • Intro
  • Course Blog
  • Projects
    • Past Student Projects
  • Resources
    • Course Instructional Videos >
      • Adobe Illustrator CS 4
      • Autodesk 123D Design
      • Cardboard Construction
      • Drill Press
      • Hummingbird Robotics
      • Inkscape
      • Miter Saws
      • TinkerCAD
      • Weebly
    • Where to buy for yourself
  • Student Blogs
  • About
    • Teacher Resources
    • Contact
  • Special Projects

Magnetic Marble Run Update #3

12/3/2016

4 Comments

 
In sharing this project out to one of my PLNs today, I realized that I had not put any final posts of student work here. So, above are some samples of final projects printed out and in place. With 40 students, a bit more printing remains. Below is a quick test run with some of these new components.
4 Comments
Brandon Holbrook
11/25/2018 09:53:03 am

This is just awesome! I'm so glad you did this. Have you updated your thingiverse upload with all the updated files?

Reply
John
11/26/2018 07:35:09 am

Thanks for the feedback. Unfortunately, because these were student models, I didn't upload them to my thingiverse page. It was a fun project, and the lower school kids got to enjoy the work of their older classmates. Best regards!

Reply
joe
10/4/2019 02:15:11 pm

yeet

Reply
billy
10/4/2019 02:16:01 pm

urmom

Reply



Leave a Reply.

    About

    This is a special section of the Creator's Studio site dedicated to journaling unique projects outside the scope of class.

    Archives

    January 2019
    March 2017
    December 2016
    October 2016
    September 2016
    June 2016
    May 2016
    April 2016
    March 2016

    Categories

    All
    3D Printing
    IoT
    Launch Pad
    Marble Run
    Particle.io
    Photon
    Topographic Map

    RSS Feed

Creative Commons License
Creator's Studio by John Umekubo is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Westside Neighborhood School
5401 Beethoven Street, Los Angeles, CA 90066
www.wns-la.org