Creator's Studio
  • Intro
  • Course Blog
  • Projects
    • Past Student Projects
  • Resources
    • Course Instructional Videos >
      • Adobe Illustrator CS 4
      • Autodesk 123D Design
      • Cardboard Construction
      • Drill Press
      • Hummingbird Robotics
      • Inkscape
      • Miter Saws
      • TinkerCAD
      • Weebly
    • Where to buy for yourself
  • Student Blogs
  • About
    • Teacher Resources
    • Contact
  • Special Projects

Magnetic Marble Run Update #2

10/19/2016

0 Comments

 
Okay, this is a quick update. After initial design drawings and cardboard prototypes, the marble run pieces have reached the 3D design phase with my 7th graders. Most students used Tinkercad to complete their work, while a couple of them chose Autodesk 123D Design. The actual printing process is going to take some time, but thought I would share a quick gallery of the models.

As these print out, we will send over to the lower school to use on the big wall in the Launch Pad!

Very nice work done by these creative, artistic and diligent 7th graders.
0 Comments



Leave a Reply.

    About

    This is a special section of the Creator's Studio site dedicated to journaling unique projects outside the scope of class.

    Archives

    January 2019
    March 2017
    December 2016
    October 2016
    September 2016
    June 2016
    May 2016
    April 2016
    March 2016

    Categories

    All
    3D Printing
    IoT
    Launch Pad
    Marble Run
    Particle.io
    Photon
    Topographic Map

    RSS Feed

Creative Commons License
Creator's Studio by John Umekubo is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Westside Neighborhood School
5401 Beethoven Street, Los Angeles, CA 90066
www.wns-la.org